What is a GPS dyno, and how does it work?
A GPS dyno estimates wheel power from how quickly a vehicle gains speed. In wasgoht's DynoRun you hold one gear and accelerate hard while the phone records GPS speed.
The app trims the trace to the acceleration phase, resamples it every 100 ms, smooths it with a Savitzky-Golay filter and differentiates it into acceleration. Force is mass times acceleration plus estimated aero drag, rolling resistance and road grade, and power is force times speed, so the inertial part is P = m·a·v.
Engine RPM comes from one calibration number: rollout, the metres travelled per engine revolution, captured once from a steady hold at a known RPM. Torque is power divided by rotational speed, and both are averaged into 100 RPM bins. The result is uncorrected wheel power and torque, shown in kW, hp or PS.
How accurate is a GPS dyno?
Read it as comparative, not absolute. DynoRun reports wheel power, which is lower than the crank figure a manufacturer quotes, and it applies no weather correction. The absolute level depends on the mass you enter, the assumed drag and rolling resistance, and the quality of the GPS fix.
Most of those errors repeat from run to run on the same vehicle, so they largely cancel in the comparison the tool is built for: same vehicle, same gear, same stretch of road, similar conditions, before and after one change.
wasgoht publishes no accuracy percentage, because it has no rolling-road validation to back one, and it is not a replacement for a calibrated rolling-road dyno. A noisy trace stays visibly noisy rather than being smoothed into a confident number.
Does it work on a motorcycle?
Yes. DynoRun has a hands-free mode built for riders, because nobody can look at or tap a phone in the middle of a pull. You start the session while stopped, put the phone in a pocket and ride, and the recording ends on its own once you come to a stop.
Only then does the app show the pulls it found, and you pick the ones to keep. Nothing is decided while the bike is moving. Calibration works the same way: ride a steady hold at a known RPM in the gear you measure in, then choose that hold afterwards, because the first steady stretch is often a cruise in the wrong gear.
Car drivers can watch the screen instead and confirm each step live.
What do I need for grip analysis?
A RaceBox logger and a track session exported from the RaceBox app as a CSV file. Grip reads that export: a short block of track, date and lap times, then one row per sample with time, latitude, longitude, speed, lap and lean angle.
Lean angle is required, because Grip derives cornering g from lean, so it is built for motorcycle sessions. The file is parsed in your browser before anything is saved to your account, and a 30 minute session is a few megabytes.
Grip then draws the traction circle, matches apexes to the same track turn on every lap and lines up to six laps on one distance axis. Every figure is an estimate of the g demand you produced. It does not measure how much grip the tyre had left.
Is wasgoht free?
Yes. Both tools are free, signing up takes an email address, and the demo needs no account at all. wasgoht is a non-commercial personal project, operated by Johannes Nothstein in Switzerland and used by its author.
It is a web app: open wasgoht.ch in the browser on your phone, with nothing to install and no app store version. The dyno needs the phone, its GPS and the mass of the vehicle, with no rolling road, OBD dongle or extra sensor. Grip needs a RaceBox session export. Runs and sessions stay in your account, so the next change has a baseline to be compared against.